Discontinued.
4/6/8 stages analog phaser/vibrato with tap tempo.
Radar Phase combines two techniques, a fully analog signal path and a modern digital control unit offering lot of unique features.
Working modes:
- NORMAL - in this mode the pedal works as a standard Phaser/Vibrato pedal, the LFO frequency is controlled with the Speed knob. The Tap footswitch allows to freeze the modulation wave at the present value. You can basically stop the sweep at some point and then, by activating the footswitch again, make it continue its travel. Expression pedal, if plugged takes control over the Speed parameter.
- TAP - in this mode the Speed knob has a different function. LFO speed is set by tapping the tempo (internally or externally), and the knob Beat sets the subdivision parameter. The available subdivisions are:
- /4, four times slower,
- /3, three times slower,
- /2, two times slower,
- 1, exactly the tapped tempo,
- x2, two times faster,
- x3, three times faster,
- x4, four times faster,
- x6, six times faster,
- MANUAL - in this mode the LFO is switched off and the overall phase shift is controlled by the position of the Expression pedal. This mode allows to use the pedal as a Phasing Wah. When the Expression pedal is not present, the phase shift can be controlled with the Depth knob.
Vibrato effect
In order to get a vibrato sound the Mix knob should be set to full wet position and the Feedback knob should be set to zero.
External tap tempo (input)
Connect the external tap footswitch (momentary) with the TapLink socket in the pedal using a standard mono jack-jack cable.
How to tap the tempo on other pedal using Radar's Tap footswitch
Connect the TapLink in/out with the TapInput on your pedal.
How to connect an expression pedal
Connect the Expression pedal output with the Radar's ExpIn socket using a stereo jack-jack cable.
